m68 slot ✓ Slot nut with bar slot 8 M6 I type
m68 slot M68 Hexagon Lock Nut to DIN936 in Grade 4 Steel Zinc & Clear Cr3 with dimensional measurements, in a range of finishes m68 slot The end rounding of the slot is not to be less than e2 An edge rounding should preferably be avoided as this increases the stress concentration slightly The
m68 slotT-nut suitable for T-nut slots DIN 508 with a width of 8mm This specific type is suitable for the ISEL PT25 T-slot plates These are often used as a clamping
m68 slot Beveled screw slot to remove screw when die is used in a machine holder Hexagon Re-threading Dies No special holder required; use standard wrenches